TV stand from ONE sheet of plywood!

This video shows how I built my own tv/stereo console table, using one single 4'x8' sheet of 3/4" plywood.

I used an online plywood sheet optimizer to figure it all out. The software allows you to enter your own part quantities and dimensions and it presents you with the best layout possible to get your moneys worth out of your plywood! I'm pretty sure my calculation only resulted in about 5% waste total.

I ripped the entire sheet down into strips and then cut each strip to length to create my 5 unique parts needed to build the table. In total I cut 100 pieces to create 20 layers of plywood.

I only used a couple tools in this video, which you can find below...

Tape measure - https://amzn.to/2rumH38
Circular Saw - https://amzn.to/2sivTIi
Stanley Square - https://amzn.to/2LGe9zE
Brad Nailer: https://amzn.to/2rD7nBc
Wood Glue: https://amzn.to/2I9k9i5
Palm Sander - https://amzn.to/2EfrLCa
Trim router - https://amzn.to/2rtWWRp
Table saw: https://amzn.to/2KXkUwe
Mitre saw: https://amzn.to/2TSI5fM

Видео TV stand from ONE sheet of plywood! канала PatonHaus