Coffee table from ONE sheet of plywood!

I used Starbond superglue in this project to fill in the voids in the plywood, you can check out all of their products here: http://bit.ly/2WqjNOw

Any purchases you make help support my channel! Thank you!
This video shows how I built my own coffee table, using one single 4'x8' sheet of 1/2" plywood, and these hairpin legs ($40 for all 4 legs!): https://amzn.to/2wjgnON

I ripped the entire sheet down into strips 1-3/4" wide x 48" long, glued them all together and fed them through the planer to smooth them out. I also added some steel strips on the bottom to provide additional strength.
A few tools and products I used in this video...

Milwaukee drill - https://amzn.to/2IaJzf0
Wood Glue: https://amzn.to/2I9k9i5
Palm Sander - https://amzn.to/2EfrLCa
Tape measure - https://amzn.to/2rumH38
Stanley Square - https://amzn.to/2LGe9zE
Circular Saw - https://amzn.to/2sivTIi
Trim router - https://amzn.to/2rtWWRp
Table saw: https://amzn.to/2KXkUwe
Beam Clamps - https://amzn.to/2WoizTP
Pipe Clamps - https://amzn.to/2Wmo5Xb
.
.

Видео Coffee table from ONE sheet of plywood! канала PatonHaus