Ford 8.8" rear end Traction-Lok clutch setups
I have finished the second volume in a two volume series on "Swapping a 5.0L engine into a Fox body Ford". This is a short clip from the chassis setup chapter in volume one. Here I'm showing the Traction-Lok clutch pack removed from the TBird. I show how to measure pack clearance without using the special Ford clutch measurement tool. I also tell how Ford's clutch design has changed since the 80"s and warn against adding fibers to increase clutch torque. Complete 8.8" rear end repair for the iron and alloy versions of this rear as well as the 9.75" is detailed in the "How To Repair the Ford 8.8" Axle" DVD. This is one of ten titles in the BadShoe Productions video series. The 5.0L engine swap DVD volume one and two is now for sale. See my web site www.BadShoeProductions.com for details on this DVD or digital downloads as well as the other BadShoe titles.
Видео Ford 8.8" rear end Traction-Lok clutch setups канала BadShoeProductions
Видео Ford 8.8" rear end Traction-Lok clutch setups канала BadShoeProductions
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
How to select the #1 thrust washer on the Ford C4/C5 transmission.How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 4 (last parts & startup)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 3 (parts installation)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird part 2 (test fitting)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 1 (preparation)How to set the #1 thrust washer size on the Ford C4/C5 TransmissionHow to use BadShoe's C6 and Fmx sizer toolsHow to use BadShoe's AOD/4R70W piston sizer toolsHow to use BadShoe's AODE/4R70W Servo & Accumulator toolRotating cycle of RC aircraft ownership.What's New with BadShoeTroubleshooting a no start concern on a EEC 4 car HDIntroduction to BadShoe's Easy Tooling ProductsHow To Rebuild the Ford 4R70W Trans. rev/intermediate clutchKeeping a seal's garter spring from popping out during installationHow to identify different versions of the Ford C4/C5 Trans.Rewiring a Ford EEC IV "speed density" harness to a "mass air" harnessHow to correctly position the converter when installing a Ford AOD trans.Welcome to BadShoe ProductionsHow To Rebuild the Ford FMX TransmissionEasy installation of the Ford 8.8" traction-lok S-spring