How to use BadShoe's AODE/4R70W Servo & Accumulator tool
This edited clip is from a live broadcast made after producing my latest "Easy Tooling" item. It's a three in one tool for the Ford AODE/4R70W automatic transmission. Designed to help remove and install the OD and Low/Rev. servo as well as the 1-2 accumulator valve. The springs under these parts are very strong which makes it hard to remove the snap rings without compressing the springs. This tool makes it easy by holding down the servo or accumulator, freeing up your hands for snap ring removal and installation. It come complete with the fixture tool made of strong, chemical resistance one inch thick PVC , two M6X65mm screws and washers, instruction sheet and center pinch bolt for compressing the OD servo, Low/Rev. servo and 1-2 accumulator covers. Note; Always wear safety glasses and this tool should only be used by technicians that are familiar with this transmission.
www.BadShoeProductions.com
Видео How to use BadShoe's AODE/4R70W Servo & Accumulator tool канала BadShoeProductions
www.BadShoeProductions.com
Видео How to use BadShoe's AODE/4R70W Servo & Accumulator tool канала BadShoeProductions
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
How to select the #1 thrust washer on the Ford C4/C5 transmission.How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 4 (last parts & startup)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 3 (parts installation)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird part 2 (test fitting)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 1 (preparation)How to set the #1 thrust washer size on the Ford C4/C5 TransmissionHow to use BadShoe's C6 and Fmx sizer toolsHow to use BadShoe's AOD/4R70W piston sizer toolsRotating cycle of RC aircraft ownership.What's New with BadShoeTroubleshooting a no start concern on a EEC 4 car HDIntroduction to BadShoe's Easy Tooling ProductsHow To Rebuild the Ford 4R70W Trans. rev/intermediate clutchKeeping a seal's garter spring from popping out during installationHow to identify different versions of the Ford C4/C5 Trans.Rewiring a Ford EEC IV "speed density" harness to a "mass air" harnessHow to correctly position the converter when installing a Ford AOD trans.Welcome to BadShoe ProductionsHow To Rebuild the Ford FMX TransmissionEasy installation of the Ford 8.8" traction-lok S-spring