How to use BadShoe's AOD/4R70W piston sizer tools
This edited live broadcast was shot with a webcam on a marginal online record feed so excuse the less than normal video and audio quality. One of the latest “Easy Tooling” product from BadShoe is this six-piece seal sizer set which is designed to make installing the Ford AOD/4R70W clutch pistons with lip seals, very easy. Normally, hard to find seal protectors are used to guide the seal lips passed the sharp step in the drums. With this kit, the sizer tools are installed on the outside and on some, inside of the piston, compressing the seals lip. The piston with tools attached, are placed in a freezer and when removed, the seal lips remain compressed long enough, allowing the piston to simply and effortlessly drop in the drum. Once in, the seals thaw and the clutch can be assembled. Wipe the tools off and use again and again. The kit includes an outer sizer for the direct, an inner and outer for the forward, and inner and outer for the intermediate. There’re also three freezer bags, a wire lip seal guiding tool and an outer seal protector for the square cut seal on the reverse piston which is installed at room temperature. Not having access to the AOD/4R70W seal tools is the number one reason customers tell me they are reluctant to take on the AOD. This kit remedies that. I also have sizers for the FMX and later C6 transmission. For more info on this tool and other BadShoe products, go to www.badshoeproductions.com .
Видео How to use BadShoe's AOD/4R70W piston sizer tools канала BadShoeProductions
Видео How to use BadShoe's AOD/4R70W piston sizer tools канала BadShoeProductions
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
How to select the #1 thrust washer on the Ford C4/C5 transmission.Welcome to BadShoe ProductionsWhat's New with BadShoeRotating cycle of RC aircraft ownership.Keeping a seal's garter spring from popping out during installationHow to install a centrifugal supercharger in a 96-97 4.6L Thunderbird part 2 (test fitting)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 1 (preparation)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 3 (parts installation)How to install a centrifugal supercharger in a 96-97 4.6L Thunderbird, part 4 (last parts & startup)How to set the #1 thrust washer size on the Ford C4/C5 TransmissionMaking air checks on the Ford C4 transmissionIntroduction to BadShoe's Easy Tooling ProductsHow to use BadShoe's AODE/4R70W Servo & Accumulator toolTroubleshooting a no start concern on a EEC 4 car HDMaking backlash adjustment on the Ford 9" rear.Rewiring a Ford EEC IV "speed density" harness to a "mass air" harnessEasy installation of the Ford 8.8" traction-lok S-springHow to use BadShoe's C6 and Fmx sizer toolsMaking end play check on the Ford C4 trannyFord 8.8" rear end Traction-Lok clutch setups