Customer States He Doesn't Know When The High Beams Are On | Just Rolled In

Submit clips and photos that you personally took on our website!
https://www.justrolledinyt.com/
👉(Not all content sent in will be used and it MUST be yours)👈

Just Rolled In Merch (all profit from merch sales donated to local foodbank)
https://www.justrolledin.shop/

👉Follow Just Rolled In on Social Media👈
Facebook - https://www.facebook.com/justrolledin
Instagram - https://www.instagram.com/justrolledinyt/
TikTok - https://www.tiktok.com/@justrolledin

Credit:
https://www.tiktok.com/@johnny.tech4
https://www.tiktok.com/@joshuasmith6062
https://www.tiktok.com/@spanner685
https://www.youtube.com/@CLAutosNw

These videos are meant to be educational and funny, so if you have any questions don't hesitate to ask!

0:00 Intro.
0:05 A new oil pan was installed as it looked like the customer hit a curb or some road debris with the oil pan.
0:15 High beam indicator covered by pictures on the dashboard.
0:26 The shop advised the customer to clean all the stuff from the centre console as it was jam-packed with garbage and other stuff.
0:35 Correct wheel adapters were purchased and installed.
0:47 010 BMW X5 35D tuned to 30psi.
0:57 Looks like the customer's friend has pulled this prank on a few other of his friends as the "turbo exhaust whistle" is slightly rusty.
1:09 New valve cover + gasket was installed and the faulty ignition coil was replaced. He said a cheap repair became a little more expensive since the customer screwed into the valve cover.
1:24 Hopefully the customer gets this looked at soon before it becomes a bigger issue!
1:31 The exterior of the windows was cleaned and the windows were re-tinted from the inside.
1:46 The technician said the cost of an OEM or aftermarket roof rack would be cheaper since you can get them starting at $70.
1:54 The vehicle was towed away to get the damages looked at. A good reminder to jack up your car on an even surface and read the owner's manual to see where to jack up your vehicle.
2:05 Destroyed clutch on a customer's car.
2:12 A new blower motor was installed and spray foam cleaned out. Maybe the customer pissed somebody off?
2:23 The mechanic didn't say what the exact issue was, but most likely the new CV axle wasn't seated properly onto the output shaft of the differential or the clip to hold them off came off or broke.
2:32 Always be careful where you drill on your car! This happens quite often.
2:41 Hopefully the customer does not tow with this trailer receiver but looks like he has a few times!
2:50 A custom boot cleaner made by a viewer of the channel!
3:01 Outro. Thanks for watching!

Видео Customer States He Doesn't Know When The High Beams Are On | Just Rolled In канала Just Rolled In