DurapatchUV™ on Stock Tanks - DL Difference

DurapatchUV™ is a revolutionary product that allows you to quickly and easily repair just about anything, including polyethylene and steel stock tanks. Watch this video to learn more!

0:00 Intro
0:05 Overview of DurapatchUV
0:38 Applying DurapatchUV to a steel stock tank
1:35 Applying DurapatchUV to a poly stock tank
2:31 Outro

Learn more about DurapatchUV and Hastings Equity Manufacturing's stock tanks at: https://www.hastingstank.com

Check out our channel to watch additional videos about DL and our products: http://www.youtube.com/user/DuttonLainson

Subscribe to our channel to get all of our videos in your feed: http://www.youtube.com/subscription_center?add_user=DuttonLainson

Watch more informational videos like this one in our DL Difference Playlist: http://www.youtube.com/playlist?list=PLskGYSV8ME6M6gYOQQmYvdZ-tAqWCvdIF

Thanks for watching!

*Music by Dan-O at DanoSongs.com.

Here is the transcript of this video:

"DurapatchUV™ is a reinforced self-adhesive repair patch activated by UV light.

This extraordinary FDA approved material can be applied to almost any surface and quickly cures hard as a rock. It's available in four convenient sizes, it can be drilled, tapped, sanded, or painted less than an hour after it's applied, and it is flexible, rot-proof, waterproof, and resistant to impacts, chemicals, solvents, and oils.

We're especially proud of how quick and easy it makes it to permanently repair terribly damaged steel and polyethylene stock tanks, so in this video, we're going to show you how previously-impossible repairs are made easy with DurapatchUV.

We'll start by creating gashes and dents in a steel tank so severe that, in the past, your only option would have been to throw it away.

Begin the repair process by removing all debris from the damaged area and thoroughly cleaning it with basic glass cleaner. Select a patch that will leave half an inch of material around all sides of the damaged area, or, if needed, you can use any standard pair of scissors to cut a small patch from a large one. Remove the white adhesive side from the patch, lay it over the damaged area, then firmly press down on the entire patch to increase the adhesive's seal and force out all air bubbles.

Next, we'll drill a 1-1/4" hole in a poly tank where the side wall meets the bottom of the tank. Until now, no repair options were available to fix catastrophic damage like this.

Remove debris and completely clean the affected area with glass cleaner, pull off the adhesive side from an adequately-sized patch, and apply it over the damaged area. Firmly press the patch onto the tank, and you can then tear off the clear film from the other side of the patch if you'd like.

The patches will cure in five minutes of direct sunlight or 50 minutes in cloudy weather, or you can shine a UV flashlight on the patches for five minutes to cure them indoors.

Once the curing process is complete, you can add water back into your tanks, made good as new with DurapatchUV.

Thanks for watching!"

If you found this video helpful, please like and share it, and visit the D-L YouTube channel for more videos about our products!

Видео DurapatchUV™ on Stock Tanks - DL Difference канала Dutton-Lainson Company