Assembling a clutch of a Stihl Brushcutter FS Serie
When starting this brushcutter with the starterrope, the head directly started turning, so the clutch was stuck. I took it out and with sandpaper I made the rings slick again, so the clutch shoe could freely turn around the ring.
When assembling the clutch shoe it was still a bit stuck between the plates, I took off a little bit of iron from the edges of the clutch. After that it rotates freely.
Content:
0:00 Check if shoe is free
1:44 Assembling of the clutch
3:48 Putting clutch on motor
4:32 Testing
Music:
Youtube Audio Library
Know Myself - Patrick Patrikios
Видео Assembling a clutch of a Stihl Brushcutter FS Serie канала Gatze Tech
When assembling the clutch shoe it was still a bit stuck between the plates, I took off a little bit of iron from the edges of the clutch. After that it rotates freely.
Content:
0:00 Check if shoe is free
1:44 Assembling of the clutch
3:48 Putting clutch on motor
4:32 Testing
Music:
Youtube Audio Library
Know Myself - Patrick Patrikios
Видео Assembling a clutch of a Stihl Brushcutter FS Serie канала Gatze Tech
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Make a Linux bootable USB in Windows & Linux | Rufus | Bios settings | From download ISO to testInstalling Linux | From Scratch | DualbootPython Tutorial from Scratch | Windows | From download to Hello World in a GUI and IDETest Husqvarna 235 ChainsawDiagnose and 'repair' a Lithium-Ion Battery | Low cell voltageTube|Pipe notch to sheetmetal flat pattern for production | Autodesk InventorHow much amps/current is required to start a diesel car ?Arduino from Scratch | 2021 | From download to blinking led | LinuxArduino from Scratch | 2021 | Installing Drivers | From download to blinking led | WindowsModeling a PhoneCase in Fusion 360 with PicturesTesting the Akaso Brave 7 LEPython Tutorial from Scratch | Linux | From download to Hello World in a GUI and IDECompiling VESC Firmware in Windows | IDE and Terminal | STM32Cube IDE | From scratchArduino Nano | 1 kHz interrupt based software PWMHow much amps/current is required to start a tractor ?Helping on the Farm | Ford 6640 SLEParametric Cablechain in Fusion 360Programming a (bricked) VESC through SWD/STLink V2 | New STM32CubeProgrammerMake a Windows bootable USB in Linux | 2020 | Bios settings | Wimsplit | From download ISO to testInstalling Fusion 360 | 2020 | Solve Blurry Display Appearance