First video recorded with CRACE 2 prototype (4K60 - unedited - headphone warning)

In this video I'm milling a big brake adapter for a my friend's '83 Mitsubishi Starion. The design is based on the one found here...
http://www.starquestclub.com/forum/index.php?showtopic=119370

The adaptive clearing op that I used to rough out most of the material (in the first setup (not shown)) was supposed to leave 0.1mm of stock for the finishing pass. Instead it seems to have cut ~0.05 too deep. I'm not sure why, but the easiest explanation is that the diameter of the tool is 0.3mm larger than it's supposed to be, which doesn't seem likely.

(This was recorded about an hour and a half before it was published. Recorded with a GoPro Hero 7 with the standard factory lens.)

Видео First video recorded with CRACE 2 prototype (4K60 - unedited - headphone warning) канала Hirudin