Expunge the Plunge - save valuable seconds in Fusion 360 CAM by plunging faster
This is probably applicable to HSMWorks and Inventor HSM as well.
Update... I disabled the feed height for all the 2D contours in this job (~43 of them in 5 setups) and the total savings was 2 minutes, 8 seconds (according to the machining time estimate). That's a savings of ~11.5% for those ops and a savings of ~8.5% for the whole project. Considering machining time only, that means I could mill 12 in the time it used to take to mill 11. Worth the risk? I think so, but I still haven't actually run the code so I may have a different opinion after I do.
Видео Expunge the Plunge - save valuable seconds in Fusion 360 CAM by plunging faster канала Hirudin
Update... I disabled the feed height for all the 2D contours in this job (~43 of them in 5 setups) and the total savings was 2 minutes, 8 seconds (according to the machining time estimate). That's a savings of ~11.5% for those ops and a savings of ~8.5% for the whole project. Considering machining time only, that means I could mill 12 in the time it used to take to mill 11. Worth the risk? I think so, but I still haven't actually run the code so I may have a different opinion after I do.
Видео Expunge the Plunge - save valuable seconds in Fusion 360 CAM by plunging faster канала Hirudin
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Aluminum GoPro EnclosureYarn and Crossneedles (3 of 3) Watching Paint Melt (Clear Powder Coat Top Layer)Using "If Then Else" logic in Fusion 360 CAM expressionsCNC Machining a Round Part with a Mill Instead of a Lathe (7075 aluminum) (4K 60)Milling a circuit board on a Novakon Torus Pro CNC millSerial Number CNC Engraving Macro - Easily add serializing ability to your NC programsA few seconds of a finished bottle cap made for Bar Z's Summer Bash '15Novakon Torus Pro CNC Mill - DIY Power Draw Bar Actuator TestCRACE 2 Demonstration (lunacnc.com is live!)Bushings 502/503 - Prerequisite: Reading 101 (21-Station Pneumatic Fixture Plate pt.3 of ?)First video recorded with CRACE 2 prototype (4K60 - unedited - headphone warning)Put An O-Ring On It (21-Station Pneumatic Fixture Plate pt.2 of ?)Real time benchtop 3D milling of a large bottle cap (pt. 2 of 3) (Torus Pro, SolidCAM, 6061)Testing My Latest Camera Enclosure and Post Processor v2.06bLaser-Cut Dovetails (proof of concept)Measuring Action Camera Enclosure Air ConsumptionReal time benchtop 3D milling of a large bottle cap (pt. 3 of 3) (Torus Pro, SolidCAM, 6061)Brother Speedio S700X1 runout and Z axis test with ~200 mm (8 inch) test barTrochoidal milling a fairly narrow and deep slot with Novakon Torus Pro and a FogBusterArduino Panasonic remote shutter release (DMW-RSL1 disassembly)Yarn and Crossneedles (2 of 3) Kapton Masking For Powder Coating Different Colors