Tool height setting Gmoccapy, need troubleshooting help
Trying to a tool height setter working in LinuxCNC with Gmoccapy. Need a lille assistance is troubleshooting why this is not working.
//////////////
Update: The INI is case sensitive. I had "Z" instead of "z"
https://forum.linuxcnc.org/gmoccapy/38034-setup-results-in-error-named-parameter-ini-change-position-z-not-defined
Видео Tool height setting Gmoccapy, need troubleshooting help канала RotarySMP
//////////////
Update: The INI is case sensitive. I had "Z" instead of "z"
https://forum.linuxcnc.org/gmoccapy/38034-setup-results-in-error-named-parameter-ini-change-position-z-not-defined
Видео Tool height setting Gmoccapy, need troubleshooting help канала RotarySMP
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
MAHO MH600E Gearbox gear change through all gears
MAHO MH400E linuxcnc conversion G83 peck cycle
The Boley 4LV top slide being cleaned up on a Klopp Shaper
Ignore S0 Branch
MAHO MH400E testing "NC ready" Circuit
MAHO MH400E - Linuxcnc retrofit - gearboxcontrol
Milling a spacer on the MAHO CNC Mill
MAHO MH 400E spindle runout
Thread Milling with linuxCNC on the MAHO MH400E
Enlarging clamping slots using the MAHO horizontal spindle
Using a concrete "Rüttler" to vibrate refractory
MAHO 400E LinuxCNC retrofit, first glass scale read out.
A message from the MAHO
Banggood incorrect delivery claim.
Testing the drag engraver
MAHO MH400E lost Motion on Y Axis LinuxCNC
CNC'ing the infamous 7x12 mini lathe - Episode 23 - Installing Linux
Polaroid modified to use Instax film- episode 2 - making the film drive.
Boley 4LV Spindle run out. TIR near 0.00mm / 0.0001" on the alignment boss
Face milling LinuxCNC Maho
Matrix kb Lang