Homemade 3 in 1 CNC - Setting up Duet 2 Connections - Part-6 by AMbros custom

This is all about setting up the board so that it will work properly. There are many videos you can find how to setup duet for 3d printer but setting it for 3 in 1 CNC is not. So if you have any question you can ask me. During the starting of this build, its seems an easy task but then almost for 80 days I almost lost figuring out why my machine is skipping steps because there is no such place where I can get the answer. Then I saw the duet board and see its properties and during the setup process, I found the emf section which is the answer to my problem. So good thing is that I am finally able to run this machine.

Setting up motor and emf problem you need to take care of.
3 in 1 3d Printer Problems / Port Detection / Thermal Runaway / Extruder Motor / Step Skipping
https://youtu.be/TMneEWzsgos

Building 3 in 1 CNC Machine - Part-1
https://youtu.be/RXyeXx2ZSt0

Building 3 in 1 CNC Machine - Part-2
https://youtu.be/arE7-d2_5Ww

Building 3 in 1 CNC Machine - Part-3
https://youtu.be/rknRRPQnMdA

Building 3 in 1 CNC - Drive mechanism, Custom Heated Bed & Laser Mount - (Part 5)
https://youtu.be/82-bONCCrLo

Building 3 in 1 CNC - Setting up Duet 2 Connections - Part-6
https://youtu.be/bNdg4X8d6eE

Setting up duet wifi
https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7

Duet 2 schamatic
https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams

G-codes & M-Codes used in Duet
https://duet3d.dozuki.com/Wiki/Gcode

3 in 1 CNC settings to put in SD card
https://drive.google.com/drive/folders/1r9arZX8uAsLOldKYueifIPUKapE7QbLQ?usp=sharing

Duet firmware
https://github.com/dc42/RepRapFirmware/releases

Config tool
https://configtool.reprapfirmware.org/Start

Видео Homemade 3 in 1 CNC - Setting up Duet 2 Connections - Part-6 by AMbros custom канала AMbros Custom 🇮🇳