Universal Joints - Part 5: U-Joint Tools and Removal

Weber State University (WSU) - Automotive Technology Department - Transmission Lab. This is the fifth in a series of videos on universal joints, constant velocity joints, and driveshafts. In this episode we learn how to remove universal joints using the proper tools.

This video series helps partially cover the following NATEF Master Tasks:
3.D.1. Diagnose constant-velocity (CV) joint noise and vibration concerns; determine necessary action.
3.D.2. Diagnose universal joint noise and vibration concerns; perform necessary action.
3.D.4. Inspect, service, and replace shafts, yokes, boots, and universal/CV joints.
3.D.5. Check shaft balance and phasing; measure shaft runout; measure and adjust driveline angles.
3.E.4. Measure drive axle flange runout and shaft end play; determine necessary action.

Subscribe to the weberauto Youtube channel for more great videos. www.youtube.com/weberauto

Visit the following website for information on how to attend our school and obtain an associates degree or bachelors degree in automotive Technology.

http://www.weber.edu/automotive

This video was created and edited by Professor John D. Kelly at WSU. For a full biography, see http://www.weber.edu/automotive/J_Kelly.html Donate to the Department of Automotive Technology at Weber state University here: http://advancement.weber.edu/givetowsu

Видео Universal Joints - Part 5: U-Joint Tools and Removal канала WeberAuto