Stack Blocks Part Five - Making the Shaft and Final Assembly
This final video centers around basic lathe work such as facing, turning, center drilling and turning and turning an angled surface, plus final assembly of the stack blocks.
Видео Stack Blocks Part Five - Making the Shaft and Final Assembly канала Toms Techniques
Видео Stack Blocks Part Five - Making the Shaft and Final Assembly канала Toms Techniques
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Hard Drive Deactivation With Cannon
Stack Blocks Part Four- Drilling the Holes and Milling the Corner Radii
Carriage Stop Clamp Part One, Sawing the Stock and Squaring Up the Part
Building a Stevens Single Shot Rifle, Part Three - The Stock, Mainspring and Target Sight
How to Grind a Sheet Metal Drill
The New Toms Techniques Shop
Stack Blocks Part Two - Sawing Out the Stock
Stack Blocks Part One - INTRODUCTION
A Simple Power Drawbar
Form Tool Demonstration
Carriage Stop Clamp Part Two, Drilling the Holes and Milling the Notch
Indicate the vise on a milling machine in just one pass
Making Scope Rings for the Browning A Bolt 3 - Part Four
Welcome Back!
Center a Rotary Table in Under a Minute Without an Indicator
Carriage Stop Thimble Part One, Order of Operations and Calculating the Ideal Diameter for the Knurl
Clamp Knurling Tool, Introduction
Clamp Knurling Tool Body, Introduction
Cutting an Internal Thread on the Atlas Lathe, Part Three - Cutting the Thread
Clamp Knurling Tool, Body, Squaring the Stock and Boring the Center Hole