Stack Blocks Part One - INTRODUCTION
My first project tutorial is a set of step blocks used as spacers when clamping work to a table. I build the project from start to finish from drawings available on the Tom's Techniques website. This is a project that won't spend time collecting dust on a shelf, but will get used all the time.
Видео Stack Blocks Part One - INTRODUCTION канала Toms Techniques
Видео Stack Blocks Part One - INTRODUCTION канала Toms Techniques
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Stack Blocks Part Five - Making the Shaft and Final AssemblyHard Drive Deactivation With CannonStack Blocks Part Four- Drilling the Holes and Milling the Corner RadiiCarriage Stop Clamp Part One, Sawing the Stock and Squaring Up the PartBuilding a Stevens Single Shot Rifle, Part Three - The Stock, Mainspring and Target SightHow to Grind a Sheet Metal DrillThe New Toms Techniques ShopStack Blocks Part Two - Sawing Out the StockA Simple Power DrawbarForm Tool DemonstrationCarriage Stop Clamp Part Two, Drilling the Holes and Milling the NotchIndicate the vise on a milling machine in just one passMaking Scope Rings for the Browning A Bolt 3 - Part FourWelcome Back!Center a Rotary Table in Under a Minute Without an IndicatorCarriage Stop Thimble Part One, Order of Operations and Calculating the Ideal Diameter for the KnurlClamp Knurling Tool, IntroductionClamp Knurling Tool Body, IntroductionCutting an Internal Thread on the Atlas Lathe, Part Three - Cutting the ThreadClamp Knurling Tool, Body, Squaring the Stock and Boring the Center Hole