There's Something TERRIBLY WRONG With My Table Saw! Should I THROW IT OUT?! (Carpenter Discussion)

Check Out Our FREE GUIDE: *25 Must-Have Carpentry Tools...Under $25 Each!*
https://www.thehonestcarpenter.com/

WHEN SHOULD YOU THROW OUT A POWER SAW? I've had a bad defect in my table saw for a while now...but recently it's gotten worse. This week on The Honest Carpenter, I talk about what happened to two of my saws, and why I've made the decision to get rid of them!

Check Out Our Other Saw Videos!:
Table Saw Riving Knife:
https://youtu.be/Q343AGb8v0E
Rip Vs. Crosscut:
https://youtu.be/aLvXo7FbEVE

There's Something TERRIBLY WRONG With My Table Saw! Should I THROW IT OUT?! (Carpenter Discussion)

Power saws are expensive, and therefore the decision to get rid of one is not easy. But there are certain defects that I think just can't be dealt with.

For instance, my table saw has developed a prolonged BLADE ALIGNMENT ISSUE. The arbor/blade mount is slightly bent, which causes the cut to open up a bit at the back.

This problem gets compounded when I BEVEL the table saw blade. The blade kerf draws the board away from the fence badly at the back of the cut. This results in a flared cut--and it's also dangerous!

Blade alignment can be adjusted, but the table saw tends to walk itself back. For that reason, I probably have to get rid of it.

Also, my circular saw fell off a table and got pranged on the concrete floor. Now the blade guard won't operate smoothly--it gets trapped in the upper housing and won't spring back. This is a NO-GO ISSUE for me! I have to get rid of it.

When would you get rid of a power saw? Let me hear about it in the comments!

Thanks for watching!
The Honest Carpenter

Видео There's Something TERRIBLY WRONG With My Table Saw! Should I THROW IT OUT?! (Carpenter Discussion) канала The Honest Carpenter