Arbor Support 7: Cat 40 Drawbar, Switching the Motor and Shrink Fitting the Bearing Sleeve
There's not much left to do! There is always several steps to get there though, and we'll be making a part for the machine to make the main part, and then use that same machine to make the main part too.
Makes perfect sense!
Видео Arbor Support 7: Cat 40 Drawbar, Switching the Motor and Shrink Fitting the Bearing Sleeve канала Tillie's in a Bottle
Makes perfect sense!
Видео Arbor Support 7: Cat 40 Drawbar, Switching the Motor and Shrink Fitting the Bearing Sleeve канала Tillie's in a Bottle
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Making a Better Chuck key
Greenerd No.3 Arbor Press
Making T Nuts for the Nichols Mill
Converting the Boice Crane Bandsaw for Cutting Metal , by the Jackshaft Method
Arbor Support 6: Welding, Boring and Sawing the Slot
Blade Guide for the Boice Crane Bandsaw Part 1
Arbor Support for the Nichols Mill Part 1
Making a Table Nut for the Nichols Milling Machine Part 1
What Size Should a Balancing Arbor Be For The Surface Grinder?
Making a Table Nut for the Nichols Milling Machine Part 2
Dressing and Inspecting the Magchuck on a Surface Grinder
Fixing the Knee on the Nichols Mill
What Size of Stock do you Need to Make a Hexagon for your Wrench?
Arbor Support 3: Finishing the Welding Jig, Getting Accurate Results with an Inaccurate Machine...
Sharing tooling between the mill and lathe
Charlie bar
Arbor Support 5: Ball-turning with an end mill, Toolmaker's buttons, and the Secret to Success....
Lamp Clamp
Table Locks for the Nichols Mill
More Upgrades To The Mill: New Overarm, Oil Change, and Restoring the Electrical System