Slicing off the integral head of a Stihl MS660 56mm cylinder.
The top of the bore now needs to be attacked with a rotary burr to clean it up; and the top of the cylinder is to be machined flat down to the top fin. The base of the cylinder is to be decked by about 7mm using the same "slicing" method. A Yamaha PW80 head will be fitted with the new engine build.
Видео Slicing off the integral head of a Stihl MS660 56mm cylinder. канала pondejim
Видео Slicing off the integral head of a Stihl MS660 56mm cylinder. канала pondejim
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Alex Selbert's CDI. Now owned by Thomas Bristol who is "burning rubber" with it.Hot smoking brined fish at around 90 deg C for 3 hours in my "oven" smoker.Mikuni VM18 idling at 1,800 rpm; on an OZ REED with 23mm intake.Jimbo's BIG ZAPPY CDI with stock magnetoMORE SPARKSSlicing the head off a combined cylinder and preparing for fitting a separate head.My final BIG ZAPPY CDI doing its thing.BRIGHT LIGHTS on my "Black Widow Maker".For Zivko and Jose. That was at 2,500 rpm before auto-retard kicks in.My CDI ignition timing test jiggerMachining a clutch pressure plate to be perfectly flat; providing better grip.Bench firing and testing of my 56mm reeded engine build..Latest engine re-build. The Zeda / CDH with a DECENT cylinder.First startup of the new 54mm build; with the crankshaft I balanced. Near zero vibes above 6,000 rpmMy SUPER PIG engine now fitted with a modified new version CDH cylinder. Initial running.My Mutiple Roll. HR 186X2 Holden.This is how easy our bikes should start from cold; immediately the clutch is dropped.ULTIMATE CDI - Basic non-adjustable version with auto-retard AND thermal compensation.A VERY USEFUL REAR WORK STAND.R I P Bill Wigzell O A M