Scan and 3D Print a Vacuum Port for the Evolution Cold Saw

I love my Evolution cold saw, but it makes a huge mess, throwing chips everywhere. Let's do something about it. I'm going to 3D scan the saw so I can design and 3D print a chip shield with a vacuum port. Will this finally give me the chip containment I'm looking for. Umm...sort of.

Tools used in this video:

Evolution 15 Inch Cold Cut Saw (Amazon*): https://amzn.to/3qAiYRM
Einstar 3D Scanner (Amazon*): https://amzn.to/3MXx4Gl
Bambu Lab X1-Carbon 3D Printer Combo: https://bit.ly/3JzYQaX
Bambu Lab Filaments: https://bit.ly/3pusOqd
Rhino Cart Welding Fixture Table (Amazon*): https://amzn.to/3za8aez
Bondhus Metric Hex Key Set (Amazon*): https://amzn.to/3eqZzwb
Bondhus SAE Hex Key Set (Amazon*): https://amzn.to/3h9bJLZ
AESUB 3D Scanning Spray (Amazon*): https://amzn.to/44G3RHT
Photography turntable (Amazon*): https://amzn.to/3rwNLl6

*These are affiliate links. When you click one of these links and make a purchase, it helps to support projects like this one.

Raw Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
http://creativecommons.org/licenses/by/3.0/

00:00 Intro
00:34 The saw that makes the chips
02:01 Scanning spray
03:14 Scanning tips for the EinScan
06:23 Combining multiple scans
08:16 Modeling from the scan mesh in Fusion 360
10:11 Adding the vacuum port
14:02 3D printing
14:37 Fitting the new part to the saw
15:59 Test cuts and evaluation
18:09 Conclusion

Видео Scan and 3D Print a Vacuum Port for the Evolution Cold Saw канала Clough42