2x72" Tilting Belt Grinder - Part 7

Part SEVEN of a multi-part video series showing the build process of my 2x72" Tilting Belt Grinder, based off of the plans created by Jeremy Schmidt.
This video focuses on the Platen itself; the support bracket for the platen; and getting these attached to the "D" plate. I also take a crack at making a support arm for the Work Table - but that didn't go very well. :-P
Part ONE: https://www.youtube.com/watch?v=jzxdltUh8gA (the motor)
Part TWO: https://www.youtube.com/watch?v=LpZEWSA9unQ (the cart)
Part THREE: https://www.youtube.com/watch?v=e4wciUkMOfY (frame base)
Part FOUR: https://www.youtube.com/watch?v=e4wciUkMOfY (cart stabilization)
Part FIVE: https://www.youtube.com/watch?v=e5cx077PWtM (tracking & alignment)
Part SIX: https://www.youtube.com/watch?v=GNd3ppLFZJ4 (fixing tracking problems)
Part SEVEN: https://www.youtube.com/watch?v=LgyMdYHwyR4 (platen & bracket)
Part EIGHT: https://www.youtube.com/watch?v=kYDImaSE1Pc (work table & holder)
Part NINE: https://www.youtube.com/watch?v=qTvV27ZLLX8 (radius jig)

Видео 2x72" Tilting Belt Grinder - Part 7 канала Todd McMahon