2x72" Tilting Belt Grinder - Part 4

Part FOUR of a multi-part video series showing the build process of my 2x72" Tilting Belt Grinder, based off of the plans created by Jeremy Schmidt.
This video focuses on adding an "outrigger" to the cart for increased stabilization; upgrading the casters; re-mounting the belt grinder frame; and then mounting the motor.
Part ONE: https://www.youtube.com/watch?v=jzxdltUh8gA (the motor)
Part TWO: https://www.youtube.com/watch?v=LpZEWSA9unQ (the cart)
Part THREE: https://www.youtube.com/watch?v=e4wciUkMOfY (frame base)
Part FOUR: https://www.youtube.com/watch?v=e4wciUkMOfY (cart stabilization)
Part FIVE: https://www.youtube.com/watch?v=e5cx077PWtM (tracking & alignment)
Part SIX: https://www.youtube.com/watch?v=GNd3ppLFZJ4 (fixing tracking problems)
Part SEVEN: https://www.youtube.com/watch?v=LgyMdYHwyR4 (platen & bracket)
Part EIGHT: https://www.youtube.com/watch?v=kYDImaSE1Pc (work table & holder)
Part NINE: https://www.youtube.com/watch?v=qTvV27ZLLX8 (radius jig)

Видео 2x72" Tilting Belt Grinder - Part 4 канала Todd McMahon