You CAN use FETTEC G4 with BLHeli32 // FULL SETUP GUIDE

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate-fpv-shopping-list

SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia

THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/

---

I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.

Buy the FETTEC G4 at:
* FETTEC store - https://bit.ly/3JgcnlE
* RaceDayQuads - https://bit.ly/3rLqJEJ
* GetFPV - https://bit.ly/3n0IJHo
* Pyro-Drone - https://bit.ly/3j6Fygc
* NewBeeDrone - https://bit.ly/3HPa6h1

MANDATORY DISCLAIMER: I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn fees by linking to Amazon.com and affiliated sites.

-- TABLE OF CONTENTS --

0:00 - Let's set up the FETTEC G4!

Download the FETTEC G4 manual at: http://www.holybro.com/manual/Holybro_FETtec_FC_G4_Manual.pdf

0:29 - ESC wiring diagram

https://youtu.be/mlQplDPdIQ4 - Why I don't care about blheli32 ESC Telemetry.

3:48 - Plug ESC to FC
5:11 - Receiver and vTX wiring diagram
9:12 - Warning for high-powered vTX
11:55 - My TX/RX wires won't reach the plug as intended
13:09 - Smoke check! I got the wiring wrong :-(
16:33 - Flash the latest firmware and install KISS configurator

Download FETTEC ESC Configurator at: https://github.com/FETtec/ESC-Configurator/releases

Download KISS configurator GUI at: https://github.com/flyduino/kiss-gui/releases

19:18 - Configure the receiver, PIDs, and motor protocol
22:05 - Configure aux modes

EdgeTX Widget setup video - https://www.youtube.com/watch?v=SAQwi6QomRg

How to set up your first OpenTX model - https://youtu.be/iwndEhssna8

24:23 - Check motor direction and order
26:41 - "Advanced" configuration of the FC
29:01 - Set up rates

KISS rate converter (the auto-calculate is not working but you can manually tweak the curves) - https://apocolipse.github.io/RotorPirates/

Видео You CAN use FETTEC G4 with BLHeli32 // FULL SETUP GUIDE канала Joshua Bardwell