Cisco SPAG: Configuring TDM Pseudowires - Part 4/6: Timing and Synchronization
In the our previous videos, we successfully configured all the components necessary for the two nodes to communicate using IP/MPLS. The next step is to configure the packet-based timing protocol which that will be used to carry the synchronization information between the two ends of the pseudowire.
Видео Cisco SPAG: Configuring TDM Pseudowires - Part 4/6: Timing and Synchronization канала SPAG Cisco
Видео Cisco SPAG: Configuring TDM Pseudowires - Part 4/6: Timing and Synchronization канала SPAG Cisco
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Tutorial - Configuring Unified MPLS Transport
Cisco SPAG: Configuring TDM Pseudowires - Part 5/6: Quality of Service (QoS)
Tutorial - Configuring Two Way Delay Measurement using Y1731 PM
Evolved Programmable Network (EPN) Operational Simplicity SDN Demo
Tutorial - Configuring CE2.0 Layer 2 Protocol Forwarding
Tutorial - Configuring ELAN Service using H-VPLS BGP Auto Discovery
Latency Demo by Ericsson
Tutorial - Configuring CFM on an ELINE Service
SPAG: Clocking & Sync Part 3/3: Configuration of Clocking and Timing
Auto IP Tutorial HQ
Node insertion demo
Cisco SPAG: Configuring TDM Pseudowires - Part 3/6: IP/MPLS and IP Routing
SLA based Service Fast Reroute
Cisco SPAG: Configuring TDM Pseudowires - Part 2/6: EVC and Bridge Domain Interfaces (BDI)
SPAG: Clocking & Sync Part 1/3: TDM and Packet-based Frequency Sync
Cisco SPAG: Configuring TDM Pseudowires - Part 1/6: Introduction and Overview
Tutorial - Configuring ELINE Services
SPAG: Clocking & Sync Part 2/3: IEEE 1588 and PTPv2
Cisco ASR900 & ASR920 Product Family Technical Webinar
Cisco SPAG: Configuring TDM Pseudowires - Part 6/6: TDM Circuits and Pseudowires