Pixhawk Locks Up with Retracts - Always Use BEC to Power Servos
This is the Castle Creations BEC used in the video: http://amzn.to/1GKLPFB
As with many lessons in this hobby I learned this one the hard way. You want to make sure and use a BEC to power your receiver, which will ultimately power your servos. I had my retracts setup to pull power from the receiver without a BEC and it consistently locked up my Pixhawk. Took me a while to figure this out and I wanted to share this with you to prevent you doing what I did: crashed in the field and another time in the garage.
Please post any questions or comments below and thanks for watching.
Видео Pixhawk Locks Up with Retracts - Always Use BEC to Power Servos канала Dennis Baldwin
As with many lessons in this hobby I learned this one the hard way. You want to make sure and use a BEC to power your receiver, which will ultimately power your servos. I had my retracts setup to pull power from the receiver without a BEC and it consistently locked up my Pixhawk. Took me a while to figure this out and I wanted to share this with you to prevent you doing what I did: crashed in the field and another time in the garage.
Please post any questions or comments below and thanks for watching.
Видео Pixhawk Locks Up with Retracts - Always Use BEC to Power Servos канала Dennis Baldwin
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
QAV500 with Pixhawk Stabilize and Rate Gain TuningServo Control/Channel Forwarding in ArduPilot4G (LTE) Telemetry and Control of Pixhawk using Pi3Demonstrating my hexcopter with APM 2.6 and autonomous flightFlaps and ElevatorAPM 2.5 ArduCopter Quadcopter Return to Launch (RTL) Field Test in Windy Conditions - Austin, TXAdding Voice Cues to the Radiomaster TX16S in OpenTXNaze32 Quick Tip - Setting up a Simple Pitch Camera GimbalMAUCH PL Series BEC & Current Sensor for Pixhawk & Cube AutopilotsRC Electric Power Systems Simply Explained (ESC, BEC, LIPO, Brushless etc)Pixhawk Unboxing and Installation in QAV500FrSky F.Port 2.0 Introduction with Xact Servos and Archer Receivers Setup(2/5) PixHawk Video Series – Power, installation, final checks and first hover5 ways to setup models in OpenTX - TX16SHow To Make a Drone Using Pixhawk Flight Controller Part 1FrSky Horus X10S: The fixed-Wing PerspectiveHerelink FPV For Pixhawk - What Cameras Works & FPV Video SetupHow To Setup INAV AutoLaunch on ZOHD Drift & AR900 WingHow to setup a Pixhawk flight controller