Загрузка страницы
Все видеоНовые видеоПопулярные видеоКатегории видео

Pixhawk Unboxing and Installation in QAV500

Thanks to GetFPV for sponsoring this video: http://bit.ly/10My7Av

This is the 1st video in a series that will show everything from installing Pixhawk to mission planning with DroidPlanner in a QAV500.

The next video will show firmware loading and configuration of APM:Copter firmware.

If you have any questions or comments please post them below and thanks for watching.

Видео Pixhawk Unboxing and Installation in QAV500 канала Dennis Baldwin
Показать
Комментарии отсутствуют
Введите заголовок:

Введите адрес ссылки:

Введите адрес видео с YouTube:

Зарегистрируйтесь или войдите с
Информация о видео
6 декабря 2014 г. 8:01:38
00:10:29
Dennis Baldwin
Теги
Правообладателям
Жалоба
Комментарии
Другие видео канала
QAV500 & Pixhawk Firmware Load, Calibration & Stabilize Garage HoverQAV500 & Pixhawk Firmware Load, Calibration & Stabilize Garage HoverHands-on: DJI’s FPV is so immersive you’ll feel like you’re flying at nearly 90mphHands-on: DJI’s FPV is so immersive you’ll feel like you’re flying at nearly 90mphConnecting Raspberry pi with Pixhawk | Get Started to run your Python code | Step by Step GuideConnecting Raspberry pi with Pixhawk | Get Started to run your Python code | Step by Step GuideQAV500 with Pixhawk Stabilize and Rate Gain TuningQAV500 with Pixhawk Stabilize and Rate Gain TuningHow to Install and Setup a GPS on your FPV Drone (4K)How to Install and Setup a GPS on your FPV Drone (4K)Make Your Own Pixhawk Raspberry Pi Drone in 36 Minutes (2020) | The Ultimate Project DroneMake Your Own Pixhawk Raspberry Pi Drone in 36 Minutes (2020) | The Ultimate Project DroneHow To Make a Quadcopter Drone For School And College Science ProjectHow To Make a Quadcopter Drone For School And College Science ProjectAPM 2.8 flight controller setup | How to make Quadcopter with APM2.8(Part 2) | Mission planner setupAPM 2.8 flight controller setup | How to make Quadcopter with APM2.8(Part 2) | Mission planner setupPixhawk Locks Up with Retracts - Always Use BEC to Power ServosPixhawk Locks Up with Retracts - Always Use BEC to Power ServosBeginner Series: Transmitter Explained - Drone Radio, Drone Controller, which to chose?Beginner Series: Transmitter Explained - Drone Radio, Drone Controller, which to chose?(2/5) PixHawk Video Series – Power, installation, final checks and first hover(2/5) PixHawk Video Series – Power, installation, final checks and first hoverS500 Quadcopter Frame Guided Assembly | Pixhawk 4 + S500 Drone Build Tutorial | Part 2S500 Quadcopter Frame Guided Assembly | Pixhawk 4 + S500 Drone Build Tutorial | Part 2(3/5) PixHawk Video Series – Tips for setting up your Taranis Radio(3/5) PixHawk Video Series – Tips for setting up your Taranis RadioTBS Crossfire & Tracer Receiver Updating Firmware Using TBS Agent LiteTBS Crossfire & Tracer Receiver Updating Firmware Using TBS Agent LiteQAV 250 with Pixfalcon Telemetry and Guided Mode Using Tower for AndroidQAV 250 with Pixfalcon Telemetry and Guided Mode Using Tower for AndroidCh4: Configuring pixhawk (PX4) and motorsCh4: Configuring pixhawk (PX4) and motors5 Reasons To NOT BUY the DJI FPV Drone5 Reasons To NOT BUY the DJI FPV DronePixhawk Gimbal Setup. Fast And Easy!Pixhawk Gimbal Setup. Fast And Easy!BROKE a $1000 drone! What went wrong?BROKE a $1000 drone! What went wrong?
Статистика портала
Яндекс.Метрика
© 2008-2024 «Информационно-развлекательный портал города Верхняя Салда»
| Карта портала | Реклама | Контакты | Сообщить об ошибке | Соглашения
salda.ws salda.ws@mail.ru
Сейчас на сайте: 512 Статистика портала