Enabling the Smart interface on an APC SMT2200I with a single pole switch
Using a hardware switch to disable the front panel controls on an APC SMT2200I in favour of enabling the traditional Smart protocol/UPS-Link protocol to be accessed from the RJ50 COM port on the rear of the unit.
On this unit, running firmware 7.1, this enables the UPS to be run like a third-generation Smart-UPS, and enables compatibility with software like apcupsd. It also allows for EEPROM programming, so parameters like battery charge voltage can be adjusted.
--
THIS VIDEO IS RELEASED TO THE PUBLIC DOMAIN
To the extent possible under law, I have waived all copyright and related or neighbouring rights to this work, according to the Creative Commons CC0 affirmer. This means that anyone is free to use this content in any manner they see fit, without my objection. However, the video may still contain copyrighted content (images, video, audio, software, etc.) that does not belong to me. WHILE I DO NOT RESERVE THE RIGHTS OF ANY PART OF THIS VIDEO, THE COPYRIGHT OF THIRD-PARTY CONTENT STILL BELONGS TO ITS RESPECTIVE OWNERS. THE COPYRIGHT OF THIRD-PARTY CONTENT IS NOT WAIVED. THE VIDEO IS PROVIDED AS-IS, AND I DO NOT PROVIDE ANY GUARANTEE OF ITS QUALITY.
Видео Enabling the Smart interface on an APC SMT2200I with a single pole switch канала FFcossag
On this unit, running firmware 7.1, this enables the UPS to be run like a third-generation Smart-UPS, and enables compatibility with software like apcupsd. It also allows for EEPROM programming, so parameters like battery charge voltage can be adjusted.
--
THIS VIDEO IS RELEASED TO THE PUBLIC DOMAIN
To the extent possible under law, I have waived all copyright and related or neighbouring rights to this work, according to the Creative Commons CC0 affirmer. This means that anyone is free to use this content in any manner they see fit, without my objection. However, the video may still contain copyrighted content (images, video, audio, software, etc.) that does not belong to me. WHILE I DO NOT RESERVE THE RIGHTS OF ANY PART OF THIS VIDEO, THE COPYRIGHT OF THIRD-PARTY CONTENT STILL BELONGS TO ITS RESPECTIVE OWNERS. THE COPYRIGHT OF THIRD-PARTY CONTENT IS NOT WAIVED. THE VIDEO IS PROVIDED AS-IS, AND I DO NOT PROVIDE ANY GUARANTEE OF ITS QUALITY.
Видео Enabling the Smart interface on an APC SMT2200I with a single pole switch канала FFcossag
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Let's get drunk and work on electronicsQDSCC121000300 Silver 38: Solar briefcase followupRECDSTRM: Reassembling the awful controller we've been working on for a long time nowAnother Barco Reference Calibrator V + working softwareOptonica SM-7100 repair notes & modsRECDSTRM: Case study: Heat induced solder joint failureTDA7492 amp module output filter capacitor myth bustingAOYUE 2901 vs. 16 mm² copper wire (real time)Pt. 2: Renovating a 72 V Elcat EV charger (Small board)Fight for fair use - takedownabuse.orgPt. 2: Renovating a 72 V Elcat EV charger (Small board)Old potatoes and boozeInstalling a 6 kW 48 V rectifier rack in the basementAOYUE 2901 handle teardown & cord replacementA plague of big crappy ebike batteries is coming.Van camper! Build log #4 - Insulation & wallsI accidentally ran over my power supply. Let's get drunk and take it apart!RECDSTRM: Let's test the taped-together industrial controller!RECDSTRM: Worst industrial controller pt. 2REC'D STRM: Working on an industrial power supply