Your trim switches are useless. Let's fix that. (OpenTX n-position switch from momentary tutorial)

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate-fpv-shopping-list

SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia

THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/

---

If you're a multirotor pilot, your trim switches are probably useless. Let's fix that. I'll show you how to turn a momentary switch or a trim switch into an N-position rotary switch, and more!

---

0:00 - Introduction
1:11 - Credit where credit is due
1:33 - Disable trim function and audio alerts
2:44 - Set up Mixer with global variable source
4:08 - Set up Special Function to adjust global variable value
6:10 - Incrementing is now working. But we're not done yet.
6:55 - Set up Logical Switch to cycle the GV back to zero
9:16 - Set up Special Function to cycle the GV back to zero
10:14 - Is it working yet? Not quite.
14:15 - One use for this feature: OSD profiles
17:33 - Conclusion

Other OpenTX tutorials you might like:

https://youtu.be/F6xTZkAfpR0 - Use in-flight adjustments feature to change rate-profiles using the RadioMaster 6-position switch (or any other switch).

https://youtu.be/0RvQFaq-Pg8 - Recover a bricked OpenTX radio with this flashing method most don't know about.

Видео Your trim switches are useless. Let's fix that. (OpenTX n-position switch from momentary tutorial) канала Joshua Bardwell