X2 Drilling Oil Channels in PM-30MVL Saddle
I clamped the saddle for my PM-30MVL to the table on my X2 mill (DIY CNC conversion) and am milling out the oil channels. I'm using an 1/8" HSS ball end mill. Feed rate is around 2 IPM (yeah, it's slow). I just used a little bit of WD40 for coolant, and I got a nice clean cut.
More information is on my blog:
http://photosandprotos.com/2014/04/14/cnc-conversion-part-6-one-shot-oiler-part-1/
Видео X2 Drilling Oil Channels in PM-30MVL Saddle канала Robert Cowan
More information is on my blog:
http://photosandprotos.com/2014/04/14/cnc-conversion-part-6-one-shot-oiler-part-1/
Видео X2 Drilling Oil Channels in PM-30MVL Saddle канала Robert Cowan
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Copperhead Pre-Charge Circuit (New and Improved!)Long Long MAAAAAAAN - Steamfest 2019 Fights ONLYPrototyping with the Gweike Cloud CO2 LaserPM30-MVL CNC Conversion Test CutLogo Inlay Project (Part 1) - CADAVC 2017 - Sgt. Cuddles vs. Physique BlackDrive Shaft ImprovementsSpindle Top Bearing SupportPM30 CNC Y Axis Speed TestOpenTX Taranis Trainer (dual radio) TutorialSimple Workbench Storage - Husky Project CenterChannel Update (April 2018)Crippling Depression V2 - PreviewCrippling Depression - AVC 2018 Fights ONLYAnxiety Attack - ARC 2018 Fights ONLYCopperhead vs. P1 Fight Recap (S05E07)Copperhead Preview (2020)Drain Bamage! - The ShellBosch FlexiClick Pegboard Holder - 3D Printed!Crippling Depression V4 - Final Overview