Загрузка страницы

New Shaft for Bull Gear, Long Workpiece Challenges

This is the follow-up video for the bull gear repair. Here we are machining the new 1-15/16" shaft requested. One end will need to be drilled in the center and tapped for a grease fitting. There's also two 1/2" keyways that are milled into the shaft. This was a long shaft at over 12' which provides a bit more challenge to handle for both lathe and mill work.

Paypal Channel Donation: https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=T325L5JZMY9LY&source=url

Support though Patreon: https://www.patreon.com/abom79

My Amazon store where I'm adding many of the tools and products I use in my own shop. Amazon.com/shop/abom79

Visit my second Youtube channel where you can follow are travels, camping, RVing, cooking, and bbq!

Видео New Shaft for Bull Gear, Long Workpiece Challenges канала Abom79
Показать
Комментарии отсутствуют
Введите заголовок:

Введите адрес ссылки:

Введите адрес видео с YouTube:

Зарегистрируйтесь или войдите с
Информация о видео
26 июня 2022 г. 0:00:30
00:27:20
Яндекс.Метрика