Fabbing up twin turbo charge tubes using materials I have laying around (exhaust pipe and flux core)

You know those really nice turbocharger intercooler piping kits, that come with mandrel bent aluminum 45s and 90s, and silicone couplers?
Yeah this ain't that.

I haven't had a twin turbo setup before so I need to join two 2 1/2" pipes to one 3" pipe, along with a couple compound bends, and wouldn't ya know it? I'm using flux core mig wire and exhaust pipe!
I also scrounged up some old couplers from various diesel trucks, along with a couple pieces that my buddy Trevor kindly sent me, to make a half decent looking setup.

I also drill a hole in the pipe leading to the throttle body and install a grommet for my IAT sensor.

I finish it off by spraying everything with rubberized undercoat to make it look like I didn't make it, but lets be real.. Some stuff can't be covered up.

-Destroked 6 litre
-Twin GT3582 maxpeedingrods 62mm turbos
-Elgin 1841-p sloppy stage 3 camshaft
-PAC 1218 springs
-20 degrees idle timing
-3 bar speed density
-Gen 3 truck intake w stock throttle body
-Homemade tri Y long tube headers

Check out my channel merch on spring!
https://stationroadratrods.creator-spring.com

Thanks to my patrons! Wynn and Jorge

youtube members link:
https://www.youtube.com/channel/UCDZ9Yt_9TU6ZAwS0WY2Ivwg/join

Thanks for checking out the video! If you'd like to help support the channel and see more awesomeness in the future, I'd appreciate you checking out my Patreon!
www.patreon.com/stationroadratrods

Видео Fabbing up twin turbo charge tubes using materials I have laying around (exhaust pipe and flux core) канала Station road Rat rods