How to Terminate an RJ45 CAT5E Tool-Less Keystone Module - The TSOC™ Minute (ep. 5)

For More Tutorials Visit: http://www.TSOC.com

How to Terminate an RJ45 CAT 5E Tool-Less Keystone Module

Materials Required:
MST-501B: Cable Prep Tool
FT4-4PC5EBLSL2: CAT 5E UTP 4-Pair Cable
TM313-8C5EBL: CAT 5E RJ45 Tool-Less Keystone Module
MST-502: Side Cutter

Step 1:
Cut the specified length of CAT 5E UTP 4-Pair Cable (FT4-4PC5EBLSL2) and insert into the Cable Prep Tool (MST-501B). Rotate in one direction 1-2 turns.

Step 2:
The CAT 5E UTP 4-Pair Cable will be scored. Remove the jacket exposing the 8 insulated conductors and a nylon thread pull string. Use the pull string to strip the jacket a further 6 inches.

Step 3:
Remove the locking clip from the CAT 5E RJ45 Tool-Less Keystone Module (TM313-8C5EBL) to open the hinged door. Separate and straighten each pair of the CAT 5E UTP 4-Pair cable according to the required wiring code. Use the Side Cutter (MST-502) to trim the insulated conductors.
Step 4:
Insert the 1st pair of the CAT 5E UTP 4-Pair Cable on a 45 degree angle into the cavity of the CAT 5E RJ45 Tool-Less Keystone Module. Ensure the insulated conductors reach the IDC contacts and close the hinged door to terminate each pair.

Step 5:
Repeat Step 4 until all pairs are terminated and verify the wiring code. Close the hinged door of the CAT 5E RJ45 Tool-Less Keystone Module and replace the locking clip when complete.

Step 6:
Insert the CAT 5E RJ45 Tool-Less Keystone Module into the designated TSOC Wall Plate, Surface Box or Patch Panel.

Видео How to Terminate an RJ45 CAT5E Tool-Less Keystone Module - The TSOC™ Minute (ep. 5) канала The TSOC Minute