Загрузка страницы

DD15 and DD13, leaking CAM seal housing Part 2

How to install your CAM housing due to a leaking CAM housing seal.

Labor involved is 8-10 hours, I believe Freightliner charges 12 hours labor for this. Injector harness replacement depends on the condition of the harness that was removed. I always replace all 6 fuel lines, seals and the high pressure fuel lines from the high pressure pump due to possible fuel leaks (Detroit recommended).

I don’t recommend using air or power tools for this job, you will need assembly grease (lubriplate works fine). I use gasket maker from Detroit Diesel to help the CAM seal, seal properly. Torque wrench is needed along with timing tools for the dual overhead CAM (most critical).

The newer CAM caps do have numbers so be sure to put them back in their correct location.

Видео DD15 and DD13, leaking CAM seal housing Part 2 канала Pedro Fuentes
Показать
Комментарии отсутствуют
Введите заголовок:

Введите адрес ссылки:

Введите адрес видео с YouTube:

Зарегистрируйтесь или войдите с
Информация о видео
16 июня 2020 г. 8:50:28
00:16:48
Яндекс.Метрика