(2/2) Making a Shift Knob for Jeep - Polishing and Etching Metal and DIY Decal Vinyl Cutting

This video is the second part of making a shift knob for my Jeep on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Knife: http://amzn.to/2ssS5xr
Vinyl Cutter: http://amzn.to/2ssRBHI
Vinyl: http://amzn.to/2t7eBxU

Lathe: https://amzn.to/2nVBrEc

PATREON PAGE: https://www.patreon.com/timnummy
BUY THIS HAMMER: https://www.etsy.com/listing/524616562
AMAZON WISH LIST: https://www.amazon.com/gp/registry/wishlist/2WFTLSXEPS8WH

Stuff on the lathe:
Quick Change Tool Holder: https://amzn.to/2oZtFee
Tailstock Drill Chuck: https://amzn.to/2pmE0jX

Lathe tools:
Boring Bar: https://amzn.to/2pmy0b1
Carbide Tools: https://amzn.to/2oRZWax
Parting Tool: https://amzn.to/2nVCeW1
Center Bits: https://amzn.to/2oRRV5n
Drill Bits: http://amzn.to/2oz9W76

Other stuff:
Cutting oil: http://amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: http://littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: http://imgur.com/KIEzu92

The real version of the motor controller: https://amzn.to/2orw43F
Datasheet for the KBIC-120: https://www.galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: http://olduhfguy.com/

Видео (2/2) Making a Shift Knob for Jeep - Polishing and Etching Metal and DIY Decal Vinyl Cutting канала TimNummy