(1/3) Making a Tailstock Hex Die Holder for Tapping/Cutting Threads on the Mini Lathe

This video is how to make a tailstock hex shaped die holder on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Green Loctite: http://amzn.to/2qhVSAd
Tap and Die Set: http://amzn.to/2pBk6SB
Layout Fluid: http://amzn.to/2qhZeDr
Knurling Tool: http://amzn.to/2pI4fCq

Part 2: https://youtu.be/0v06IauXoRY
Part 3: https://youtu.be/W2ed9YpXC1E

Lathe: https://amzn.to/2nVBrEc

Stuff on the lathe:
Quick Change Tool Holder: https://amzn.to/2oZtFee
Tailstock Drill Chuck: https://amzn.to/2pmE0jX

Lathe tools:
Boring Bar: https://amzn.to/2pmy0b1
Carbide Tools: https://amzn.to/2oRZWax
Parting Tool: https://amzn.to/2nVCeW1
Center Bits: https://amzn.to/2oRRV5n
Drill Bits: http://amzn.to/2oz9W76

Other stuff:
Cutting oil: http://amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: http://littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: http://imgur.com/KIEzu92

The real version of the motor controller: https://amzn.to/2orw43F
Datasheet for the KBIC-120: https://www.galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: http://olduhfguy.com/

Видео (1/3) Making a Tailstock Hex Die Holder for Tapping/Cutting Threads on the Mini Lathe канала TimNummy