How to Electrically Wire Up a 12 Volt DC Hydraulic Pump Power Pack Twin Solenoid Coils & Thermistor

Wiring up or connecting a 12 Volt DC Electric Hydraulic Pump or Power Pack is not too complicated if you have the right instructions, tools, cables, and connectors. This video shows you how.

Make sure to carefully follow all the instructions and DO NOT use smaller cables than indicated in the Video for the main Motor supply to the main positive and negative terminals. Smaller Cables will Overheat and may possibly create a fire hazard.

If you're in the US and are looking for a new or replacement power pack try this eBay seller.
http://ebay.us/KQuNi9

This 12 Volt DC hydraulic power Unit will generate 3000 psi and 5 Lt/min. Designed for Intermittent Use Only eg full power for 3 minutes then rest for 30 minutes.

If you're in Australia looking for a 12 or 24 V DC Hydraulic power pack eBay has a good range try.

http://ebay.us/57jfM0

The 2.5-inch cylinder bore will produce 6.2 tons of push & 3.9 tons of pull at 3000 psi.

need a Wiring diagram E-mail us at sales@mhfgc.com.au

Music by www.bensound.com

Timestamps
0:00 Introduction
0:13 What you will need
0:32 Colour Wiring Diagram (colour is best)
0:37 The motor's Thermistor wires.
0:50 How push buttons on the pendant control the solenoid coils on CETOP 3 solenoid valve,
2:03 to 3:22 Lets Wire Up, Descriptions and Stills for more clarity.
3:22 to 7:22 "Hardy the Electrician" wires the Double-acting Hydraulic power pack up.
7:22 to 8:12 Rod "The Hydraulics Tech" tests the system after filling with oil and connecting up a double-acting cylinder.

#HowToWireUpa12VoltDCHydraulicPumpPowerPack#ENGMATTEC#HYDRAULIC.ONLINE

Видео How to Electrically Wire Up a 12 Volt DC Hydraulic Pump Power Pack Twin Solenoid Coils & Thermistor канала HYDRAULIC.ONLINE GOLD COAST