#113: Basics of Transistor bias point and the class of amplifier operation
Please note that towards the end of this video, where I am showing different bias conditions, that the resistor connected from base to ground is actually 4.7kohms, not 2.7k as shown in the video. This is corrected in the show notes available below. This video gives the basics of the bias point, also called operating or quiescent point, of a bipolar transistor (BJT). For a BJT, there are three operating regions: Cutoff, Active and Saturation (note, these names differ a little when dealing with FETs). The Q-point will influence the "class of operation" of an amplifier circuit. Class A, B, C and AB are discussed and demonstrated. A copy of the video drawings can be found here:
http://www.qsl.net/w/w2aew//youtube/Bias_point_and_Class_of_operation.pdf
Видео #113: Basics of Transistor bias point and the class of amplifier operation канала w2aew
http://www.qsl.net/w/w2aew//youtube/Bias_point_and_Class_of_operation.pdf
Видео #113: Basics of Transistor bias point and the class of amplifier operation канала w2aew
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
#114: Tutorial: Common Emitter, Common Collector, and Common Base Transistor amplifiers#185: Back to Basics: Bipolar Transistor bias circuits and Beta dependence#136: What is a dB, dBm, dBu, dBc, etc. on a Spectrum Analyzer?What are the differences between Class A, AB, and Class D amplifiers?#84: Basics of Ferrite Beads: Filters, EMI Suppression, Parasitic oscillation suppression / Tutorial#82: How to use a Diode as a Switch / Diodes as Switches / Basics of Diode SwitchesTransistor Base Bias Circuits - Finding The DC Load Line & The Q Point ValuesBJT - Voltage Divider Bias CircuitTSP #23 - Tutorial on the Design and Characterization of Class-B and AB AmplifiersTransistors biasing, and amplifiers#65: Basics of using FFT on an oscilloscopeTransistor Amplifiers - Class A, AB, B, & C Circuits#75: Basics of Opamp circuits - a tutorial on how to understand most opamp circuits#219: Back to Basics: Introduction to Field Effect Transistors JFET MOSFET#170: Basics of IQ Signals and IQ modulation & demodulation - A tutorial#123: Build a crystal oscillator from schematic thru prototype construction and testing - DIYSparkFun According to Pete # 36: Transistor Biasing Configurations#67: Basics of Common Emitter Amplifier Gain and Frequency Response with Measurements#273: Common Emitter Amplifier Design Tips & Shortcuts