Sheet Extrusion Pre-Start, Start-up, and Steady-State Procedures

Here is an except from Lesson #5 of Paulson Training's Sheet Extrusion Technology - "Pre-Start, Start-up, and Steady-State Operating Procedures". Details on the complete program can be found at:
http://www.paulsontraining.com/products/sheet-extrusion-technology/

The complete Sheet Extrusion Technology interactive video training program consist of 7 lessons or a total of about 10-12 hours of training. Sheet Extrusion Pre-Start, Start-up, and Steady-State Operating Procedures establishes important standardized procedures for starting up and operating a sheet extrusion line to consistently produce good plastic sheet output.

Everyone on your production floor should take this complete lesson. It teaches everyone the same techniques and terminology minimizing the chances of miscommunication and wasteful mistakes.

The 7 lessons in Paulson's Sheet Extrusion Technology are titled as follows:

Lesson 1 -- The Sheet Extrusion Line: Parts and Operation
Lesson 2 -- Sheet Extrusion Dies
Lesson 3 -- Controlling Plastic Flow in the Die
Lesson 4 -- Plastic Behavior in the Sheet Extrusion Line
Lesson 5 -- Pre-Start, Start-up, and Steady-State Operating Procedures
Lesson 6 -- Safety and Shutdown Procedures
Lesson 7 -- Troubleshooting the Sheet Extrusion Line

Видео Sheet Extrusion Pre-Start, Start-up, and Steady-State Procedures канала PaulsonTraining