Milling Machine Workbench Cabinets Build
G'day everyone,
In this video I will be making some modifications to the mill table which I made when I bought the mill back in 2021. The table is made from welded box section steel and it does a good job for the size of mill I have. At the time I was planning on adding some drawers and cabinets but didn't due to time constraints. I have had some spare time over the past two weeks so I thought that I would give it ago. Plus I needed the extra space.
In this video I will weld the frame for the sliders and I will make the drawers from pine wood.
#diy #millingmachine
Timestamps
0:00 - Introduction
1:07 - Welding Up The Support Frame
3:53 - Making The Drawers
8:04 - Final result and Tour
Видео Milling Machine Workbench Cabinets Build канала Artisan Makes
In this video I will be making some modifications to the mill table which I made when I bought the mill back in 2021. The table is made from welded box section steel and it does a good job for the size of mill I have. At the time I was planning on adding some drawers and cabinets but didn't due to time constraints. I have had some spare time over the past two weeks so I thought that I would give it ago. Plus I needed the extra space.
In this video I will weld the frame for the sliders and I will make the drawers from pine wood.
#diy #millingmachine
Timestamps
0:00 - Introduction
1:07 - Welding Up The Support Frame
3:53 - Making The Drawers
8:04 - Final result and Tour
Видео Milling Machine Workbench Cabinets Build канала Artisan Makes
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Making Spline Shafts For a GEARBOX (Internal Splines too)BUILD: A Toolmakers Bench Block (Staking Anvil)Making an Inverted Live Centre for the LatheMaking A Tandem ACME Tap - Its A Bit WeirdMaking a BIG Set of V Blocks for the Milling Machine | Vise JawsHow I Made My Other Face MillMaking A fly Press | Part 4 - Pressing Bearings And Bending MetalMaking A Collet Chuck For The LatheSimple Machinist Hammer BuildMaking A Broach To Cut KeywaysLathe Trepanning - 99.9% Not Brain SurgeryFixing An Overdue Mistake - Morse Taper Slitting Saw Arbor BuildLathe Buying Tips - Don’t Make The Mistakes I MadeMaking Square Holes With A Square BroachCNC Dividing Head Cutting Gears - M1 Z57Making A Power Feed For The Milling Machine | Cheaper And BetterLathe | New Mods, Maintenance & TeardownThe $600 Mini Lathe - 4 Years laterMaking A fly Press | Part 3 - Ram block, Gibs and LeadscrewMaking A Small Hand Plane