Torch cutting 101
I like to use a 2-1/4" X 2-1/4" solid aluminum bar as my guide. It's the perfect size to rest the edge of the torch nut while using the larger Victor torches. Theres not much of an edge there but it works. It does take practice though. I also prefer to push the torch instead of dragging only because I dont like burning my pants or boot laces. Like anything else, at first you may struggle but after you get the hang of this, then it should be smooth sailing from here. Cant get better unless you try it! 😕 Hope this helps.
Видео Torch cutting 101 канала I C Weld
Видео Torch cutting 101 канала I C Weld
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Lincoln Electric SAM-650CAT 140M IssuesAxle Housing ModificationsFord Manual Transmission Weld Repair.Arc Gouging and Stick Welding.Cutting Steel Through Concrete BackerWorn Skidsteer Sweeper bucketDrill rig Kelly bar adapter.Gooseneck Trailer Deck Repairs.Broken Hydraulic Breaker mount.New Plasma Cutter AttachmentThank you.Foundation Drill Rig Modifications.Lots of Torch Cutting. Auger Repairs(Part 2) Front End Loader Bucket Repairs.Aluminum Tungsten selection updateGoose Neck trailer repair.Axle Housing welding repairsBig Rig Axle Spring Perch swap.Vermeer SC372 Design problems??Tar holding tank mods.