FreeCAD 5 simple 3D models, part 36

FreeCAD 5 simple 3D models, part 36
Welcome to the channel Miri tech workshop.
My name is Miro in this video there is an accelerated recording of the modeling of five 3D models. During the entire process in FreeCAD, I primarily used Part Design and Sketcher. Some models may have been created using incorrect procedures, but some tips may inspire you. If you have ideas or constructive criticism, please share them in the comments. Have a nice day :)

1.
In today's video, I drew a 3D model of a part, which may look complicated, but the modeling was quite simple. I chose "Part design" to start and "Create slot" to create the base of the 3D model, I entered the necessary dimensions, and we can publish how it was done using "Constrain vertically". I created a 3D model with the "Pad" function and selected 2 flat surfaces from both sides of the model
2.
In today's video I will show you in software FreeCAD version 0.21.1. how to 3D model This time I modeled a simple 3D model in Part design "Create additive cylinder" on which I entered the required dimensions.
3.
In this video I drew a box in which I filled the corners. The vertical fill had a hole created in the corners. I modeled the 3D part in Part design as follows: I created a new document, I chose a plane and in the sketch I drew a "Centered rectangle" from the center, I entered the dimensions and thereby removed all the degrees of freedom and then the sketch was colored green. I used the "Pad" function to create a 3D model
4.
In this video, I drew a 3D model of a rotating part with protrusions in Part design, I chose a new file and selected the plane in which I drew the sketch in the next step. I created two circles "Create circle", an inner circle was created on which I entered the necessary dimensions after removing the degrees of freedom,
5.
In this video I drew a dumbbell model. It's a simple model where I drew a cymbal to show other interesting procedures. I proceeded by choosing Part design to begin with and creating a new document, I chose the Additive cylinder function to create a cylinder. In the model of the cylinder, I defined the necessary dimensions
1. 3D model. 00:00
2. 3D model. 02:03
3. 3D model. 03:33
4. 3D model. 06:34
5. 3D model. 09:24

Vitajte na kanáli Miri tech workshop. Moje meno je Miro v tomto videu je zrychleny zaznam z modelovania piatich 3D modelov. Počas celého procesu vo FreeCAD som primárne využíval Part Design a Sketcher. Niektoré modely mohli byť vytvorené pomocou nesprávnych postupov ale niektore tipy vas mozu inspirovat. Ak máte nápady alebo konštruktívnu kritiku, podeľte sa o ne v komentároch.
Prajem pekny den :)
#freecad #partdesign #3dmodeling #sketch

Видео FreeCAD 5 simple 3D models, part 36 канала Miri tech workshop