TDR250 YPVS Power-valve install Ep.2 #1147
The second video in the series covering the top end rebuild of Yamaha's infamous TDR250. This episode covers the inspection & diagnosis of failure of the old power-valves & the full, step by step installation of the new Genuine Yamaha power-valves, bushes and all related seals.
The video includes all specifications & torque settings required to complete the task in line with Yamaha's factory workshop manual.
A number of other Yamaha engines of this era were also equipped with YPVS and the procedures covered in this video will also apply to the Power-valve replacement on those models too (though you will need to obtain the specific workshop manual for your bike for specifications and torque settings as these may differ slightly to the TDR).
The next video in this series covers installing the rebuilt barrels over the pistons & onto the crankcase.
Should you have any questions or require any further info then please just comment below and I'll do my best to get back to you as soon as I can.
Andy Mechanic!
Видео TDR250 YPVS Power-valve install Ep.2 #1147 канала Andy Mechanic
The video includes all specifications & torque settings required to complete the task in line with Yamaha's factory workshop manual.
A number of other Yamaha engines of this era were also equipped with YPVS and the procedures covered in this video will also apply to the Power-valve replacement on those models too (though you will need to obtain the specific workshop manual for your bike for specifications and torque settings as these may differ slightly to the TDR).
The next video in this series covers installing the rebuilt barrels over the pistons & onto the crankcase.
Should you have any questions or require any further info then please just comment below and I'll do my best to get back to you as soon as I can.
Andy Mechanic!
Видео TDR250 YPVS Power-valve install Ep.2 #1147 канала Andy Mechanic
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
TDR250 New 0.9mm head gasket & YPVS setup Ep.6 #1151Yamaha Power Valve: Alligned to Hole or to Exhaust Port? [YPVS DT 125 RE/X]TDR250 fitting the barrels Ep.3 #1148Two Stroke Power Valve Explained (in detail)Honda CB250N Engine Restoration | CB250 Hawk Engine RestorationTDR250 Top end rebuild PROBLEM Ep.5 #1150TDR250 big end check & new piston install Ep.1 #1146Ducati 959 Panigale BrenTuning Handheld Tuner - ECU FlashArlan Talks About Porting Sphinx CylinderYamaha TDR 250 front fork rebuild #1607KTM 300 XC-W Top End Rebuild | Part 2: Power Valve RebuildYPVS RD350LC & BANSHEE YZF 350 PARTS RACE RD LCTransfer ports 1 part 4TDR250 fitting the cylinder head Ep.4 #1149démontage et remontage valve ypvs 125 DTRYamaha TDR250 - JL power pipes flat out!! POV + Fly by - ** 2 stroke screamer **Arlan Talks About CR350 PowervalveCOMO AJUSTAR VALVULA YPVSHJR5 RZ350