YOUR NEXT LEG VISE....PLEASE WATCH!

I wanted to build my leg vise ever since the day I built the bench.
I took some 2x8 stock and milled it down to the size I wanted. I wanted a 9 inch jaw but wanted to reduce the wood on the leg itself to reduce weight on the Yost screw and the linear bearing.
I cut the lumber to length.
I glued the timber on a flat surface and ran it through my planer. I took the grain and set the two pieces to match up and glued them together.
After the glue dried I milled flat and planed them flat with my Stanley #5 plane. I held the vise in place on the bench where I wanted it to be and drilled my hole for the screw vise. I them connected the vise with the Yost screw and found where I wanted to place the 30mm linear bearing. I had to make sure that the linear bearing would not be in any bind so this was critical. I drilled the linear hole with a 12" extension and a 1 1/2" hold saw. I used a ring on the shaft of the bit extension to keep me level to know I was not drilling in an upward or downward position. I then mounted the linear bearing inside the hole with stainless steel screws. I took the 30mm linear rod (1055 Carbon Steel, 30 mm Diameter, 500 mm Long) that I purchased from Mcmaster-Carr and used epoxy to set it inside the leg chop. I finished it off with boiled linseed oil to match the table. I put some leather on the inside of the jaws for better grip. Now onto my next vise on the end of the bench. What do you guys think?
VXB Brand LMEK30LUU 30mm Long Square Flanged Bushing Linear Motion Type: Flanged Linear Motion Ball Bushing Size: 30mm x47mm x123mm Quantity: One

https://rb.gy/0elpws

Yost Tools, 18" Vise Screw, Model Y18SS Leg Vise

https://rb.gy/d3lkfz
IRWIN 12 x 1/4 In. Bit Extension
https://rb.gy/dercxt

1 1/4" Speed bit Lowes
https://low.es/38U0UaC

Linear Motion Shaft-Mcmaster-Carr
1055 Carbon Steel, 30 mm Diameter, 500 mm Long
6112K74
https://bit.ly/3huNd6a

Видео YOUR NEXT LEG VISE....PLEASE WATCH! канала Marty Of All Trades