I make an Industrial Style Coat Hook using Rebar - MIG Welding Project

In this video, I make an Industrial Design Coat Hook, using a rebar rod to give it the real industrial decor look. It was a good welding project for me, I did not heat the steel for bending I just used bits of pipe that slid over the rebar to get the leverage for the bend.

The steel plate is 3mm thick, 105mm long and 42mm wide.
The Rebar is 13mm rebar
Main tools used, Welding Magnets V-Pads, MIG welder, angle grinder, Hammer, and a Drill.
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.

Hope you found something of use in my video or at least found it entertaining.

-----Product Links-----
The swivel “V” magnets you see me using in this video, Amazon: https://amzn.to/3DCya4W
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker. Amazon: https://amzn.to/3kHrXfo
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens. Amazon: https://amzn.to/2WKKpeE
These are similar to the small ones I use, Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°, Amazon:https://amzn.to/2WN9Fkr

-----Filming Equipment used in this video----
1)Camera - Canon EOS M6 Mirrorless Digital Camera with 15-45mm Lens. Amazon: https://amzn.to/3DIKnF4
2)Camera Tripod - Vanguard Alta Pro 2+ 263AB Tripod with Alta BH-100 Ball Head. Amazon: https://amzn.to/3yB8hP5
3)Camera Microphone - Rode Microphones VideoMicro Compact. Amazon: https://amzn.to/2WFmQVd

►►Subscribe to our Channel for more videos ►► http://bit.ly/2ULxLJogavinclark

Gavin Clark DIY

DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!

Видео I make an Industrial Style Coat Hook using Rebar - MIG Welding Project канала Gavin Clark