New drive for the Mini Lathe - Making Poly-V pulleys

I'm upgrading the Mini Lathes drive and electric at the moment. For the new motor I bought a pulley which I thought will fit to the old tooth belt. But it doesn't and instead the new drive runs incredible rough and rattles crazily.
For this reason I planned to change the drive to Poly-V belt and pulleys as they run naturally smoother than tooth belts.
It isn't that easy to find the Poly-V belts in this small sizes. First I preferred the smallest profile PH but this isn't available in the right size so I had to change to the next bigger PJ profile. For this I had to make two pulleys which I show in this video.

I hope you enjoy this little episode.
Feel free to comment if you have questions or suggestions. And if you like the content, consider to like and subscribe :)
Thank you very much!

00:00 Intro
00:22 Making the bigger pulley blank
01:26 Making the smaller pulley blank
02:51 Testfit and little Poly-V excursion
03:39 Turning an arbor for further clamping the blanks
04:02 Finding the right tool for the V-grooves
04:26 Turning the V-grooves
06:02 Slotting the keyways
07:01 Final installation
-Making a dial for Mini Lathes carriage: https://www.youtube.com/watch?v=8Ivp5...- Adjustable Carriage Stop: https://www.youtube.com/watch?v=EpWPT...- Mini Lathe compound angle modification: https://www.youtube.com/watch?v=rdkoT...- Mini Lathe tailstock fine adjustements: https://youtu.be/5Kv2QG9DXf8- - Mini Lathe bearings for the compound slide: https://youtu.be/EOeR_ed5HsY

Видео New drive for the Mini Lathe - Making Poly-V pulleys канала We Can Do That Better