Reset the ABS, VSC and Brake system warning lights on Toyota Prius.

A diy, step by step video demonstration on how the ABS, VSC and Brake system warning lights were reset on 2008 Toyota Prius.

#Prius #resetlight #resetabslight #resetvsclight #resetwarninglight #abslight #vsclight #warninglight #Toyota

This is reset procedure only, if indicator lights keep coming on after they are reset the problem is likely still occurring.

Take the vehicle to have a Toyota and/or ASE technician with diagnostic tools to run through the ABS and braking system.

If you must troubleshoot yourself, next steps would likely be to check:
Computer maintenance codes
Electrical fuses
12 volt battery voltage
Brake fluid level
Brake pad/shoe wear
Continuity of wires to the brake system sensors
Faulty sensors
ABS pump and/or actuator

In this video a jumper wire from an electronics kit was used. Others have used a paper clip as the jumper. Any wire with a small enough gauge would lead to similar results.

In this video:
Jumper Wire Kit 140 Piece

Thank you for your support:
Subscribe now to TryAdaptLearn and view other videos on this channel. Comments and likes are welcomed and will also help support this channel.

Disclaimer:
This video is for demonstration and entertainment purposes only. All viewers must take responsibility for their own choices and actions. The creators of this video and anyone recorded in the video are not responsible and do not assume any responsibility for all purchases, damage, injury, death or dismemberment resulting from the performance of any operation in this video. Use the proper parts, specifications and safety procedures for your own application.

Видео Reset the ABS, VSC and Brake system warning lights on Toyota Prius. канала TryAdaptLearn