Radware Alteon VM Configuration || Alteon Load Balancer Setup || Radware Alteon VM Initial Setup...

To deployAlteon VA for all environments
1.To get the management IP address, do one of the following:
—In the vSphere interface, click theSummarytab of your defined Alteon VA to view the IP
address of the management network.
—In the Alteon VA console, enter/info/sys/mgmt.
2.To disable the DHCP, enter/cfg/sys/mmgmt/dhcp disable, and configure the management
network manually using the CLI as follows:
a.To configure the IP address, enter/cfg/sys/mmgmt/addr ip address
b.To configure the mask, enter/cfg/sys/mmgmt/mask mask
c.To configure the gateway, enter/cfg/sys/mmgmt/gw default gw
d.To enable the configuration, enter/cfg/sys/mmgmt/ena
3.Enable the management interface access, as follows:
—To configure Telnet, enter/cfg/sys/access/tnet e
—To configure SSH, enter/cfg/sys/access/ssh/on
—To configure HTTPS, enter/cfg/sys/access/https/e
4.To apply the configuration, enterapply.
5.To save the configuration, entersave.
For more information on configuring Alteon VA, see theAlteon CLI Application Guide.
Further configuration of Alteon VA can be performed through one of the management interfaces.After the license is set and the IP addresses have been configured on the data ports, Alteon VA isable to receive configurations through the data ports.
Please like and share this video with your friends and family. Also, Don't forget to subscribe to our channel for more videos.

কোন হেল্প লাগলেঃhttps://www.facebook.com/dailysupport.net
E-Mail: alsafiuladiat@gmail.com

Видео Radware Alteon VM Configuration || Alteon Load Balancer Setup || Radware Alteon VM Initial Setup... канала Daily Support