Promaster sink cabinet

Installed pass throughs for the water heater hoses that will go to the engine compartment and connect to the heater hoses for the engine. The water heater is a sailboat water heater that uses engine coolant to heat the water to engine temp. This is too hot to use, so it has a blend valve with a cold water feed that blends cold water into the hot as it exits the heater. This makes 195 degree water in the unit cool off to whatever temp we want to set, which stretches the 6.4 gallon tank to about 11 gallons of usable hot water. I should be plumbing into the engine cooling system Saturday, and then I'll vacuum the whole system and suction coolant from front to rear.
Built out the inside of the cabinet today also. Then I set the sink and faucet in place and ran the hoses for the faucet to the water lines by the heater.
Going to probably use shelf paper for the inside of the cabinet. I'll take it back apart and install it on the parts. Planning on picking some up tomorrow.

Видео Promaster sink cabinet канала Robert Johnsen