3D Printing an RC Car for the First Time

I enjoyed building and driving this fully 3D-printed RC car in the last couple of months. Even the gears are fully printed in PLA, and they work smoothly (if I keep the power on a decent level). I found this fantastic project called Tarmo on Reddit. This is currently version four and the engineer is working on the fifth one. I was immediately impressed by the community around it. They have a ton of hacks and many people who are continuously helping each other.
The car itself has a crazy torque. I had to limit the power to 25% to stop breaking the gears, and it still pushes like a horse. I made a couple of jumps, only breaking a few pieces. I'm glad it takes just a couple of hours to be on the streets again.

Timestamps
0:00 Chassis and Differential boxes
2:30 Drive motor and Driveshafts
3:29 Locked and Open diff
4:37 Servo
4:54 Front transmission and suspension
6:12 Rear transmission and suspension
7:03 Steering system
8:25 Wheels
9:07 Wiring electronics
10:21 First tests
10:35 Reveal!

Subreddit:
https://www.reddit.com/r/EngineeringNS/

Instructions to build the car yourself:
https://docs.google.com/document/d/1hfrpDU1DQm6QKrioJsxxcMdq8ormYTlwAHaiswDuSHI/edit

Music:
You & I by Soyb & Amine Maxwell
https://soundcloud.com/soybmusic
https://soundcloud.com/aminemaxwell
Creative Commons — Attribution 3.0 Unported — CC BY 3.0
Free Download / Stream: http://bit.ly/l-you-and-i
Music promoted by Audio Library https://youtu.be/NS71HLgd9q4

Malecon by Soyb & Amine Maxwell
https://soundcloud.com/soybmusic
https://soundcloud.com/aminemaxwell
Creative Commons — Attribution 3.0 Unported — CC BY 3.0
Free Download / Stream: https://bit.ly/al-malecon
Music promoted by Audio Library https://youtu.be/xbWzYbtMgIE

Видео 3D Printing an RC Car for the First Time канала Leandro Linares