No Scuff Manual Tire Change Bar

Now you can run Aluminum and Chrome rims through your manual tire changer. No scratches and no torn beads. Perfect for those Harbor Freight Tire Changers.

Bearings 99502H (no clip) : http://amzn.to/2mTFFgB
No Mar Removal Ends: http://amzn.to/2mTIsWP
Plastic protection for install (better than milk jugs): https://amzn.to/2oYIORA
Tire LUBE is a MUST: http://amzn.to/2m8tSL7
$50 Manual Tire Changer Machine: https://amzn.to/2mLAiVu
Saw I used to cut the steel Evolution Evo 380: http://amzn.to/2lOGxBZ

4 foot 3/4 black gas pipe from the Home Depot/Lowes
5/8" bolt and nut for bearings

For the mounting end I used 3/16" steel 4"x4" angle iron cut to 2" wide. I cut the short end to around 1" and left the other at 4". You don't need angle iron and could just bend or cut/weld an angle piece together. 1/8" material is too thin and I would use 3/16" or 1/4" material. Bearings are 1/8" back from the face of the HDPE plastic. The plastic is around 1/4" thick so the bearings are around 3/8" from the inside of the angle iron. You can go to my Facebook page listed below for close up pictures. If you bought everything this would cost you around $25 with a spare $10 tip.
To see more detailed photos Go to my Facebook Page: https://www.facebook.com/Sixty-Five-Ford-YouTube-Channel-808758422528173

Mojolever Mojo Lever and No Mar make a similar bar if you want to buy one.

Видео No Scuff Manual Tire Change Bar канала sixtyfiveford