Instant Hot Water - Save Water Every Month - Do It Yourself

Autocirc: https://amzn.to/37M0Icz
Due to requests, I am now including links to products when possible. These links are provided for reference, no company or individual paid to be in this video. Depending on the vendor, a small commission might be paid and would be used to support adding content to this channel.
Amazon Prime free 30 day trial: https://amzn.to/3g9mwCL
Amazon Tool Deals of the Day: https://amzn.to/3eUGcsD
How many times have you turned on your hot water tap and waited, and waited and waited for hot water?

For most of us this happens everyday. In fact, the average family of four wastes 15 thousand gallons of water each year waiting for hot water to appear at their tap. Waiting for hot water not only wastes a precious natural resource, water, but it also throws money down the drain in the form of higher water, sewer and utility bills.

So how can you correct this problem? Installing a device to give you instant hot water.
The Autocirc pump is installed under the sink or faucet farthest from the water heater—where hot water usually takes the longest amount of time to arrive.
A built-in temperature sensor or thermostat automatically senses when the water in the line drops below 95 degrees. When this happens, the pump turns on and begins re-circulating the water.
The pump takes the water from the hot water supply line and pumps it through the cold water supply line into the hot water heater to be re-heated.
The Autocirc also has a 24 hour timer on it. This allows you to pre-set the pump to turn on at a specific time, for example, you can set it for just before you get up in the morning so you can have instant hot water for your shower.
Or you can set it for any time of high demand hot water usage.

7 Easy Installation Steps:

1) Select the sink where hot water takes the longest to arrive
2) If you don't have an outlet under that sink, call an electrician and have one installed
3) Turn off angle stop valves (water valves under sink) and disconnect existing supply hoses from the hot and cold water supply inlets of the faucet
4) Attach 3/8” end of the new hoses to pump housing and attach other ½” end to the hot and cold water supply lines
5) Attach existing supply hoses from the angle stop valves to the ½” hot and cold water inlets of the pump
6) Set pump timer for desired operation period
7) Install the Autocirc to the wall under the sin with the bracket provided. Turn on the water at the angle stop valves and plug in the 115 volt cord into the outlet. Turn on the desired run mode setting and the system is now operational.
Tools Required:

-Adjustable wrench
-Screwdriver

Parts Required:

-Autocirc Pump which includes pump with built-in timer, 6 ft. line cord, and wall bracket
-Two stainless steel or fiberglass reinforced flexible hoses (1/2” X 3/8” fittings) at a length required to suit your installation.

NOTE: if you are installing the Autocirc under a kitchen sink, and plan to use the same outlet that your garbage disposal is plugged in to, the Autocirc will not work. That’s because these type of outlets are known as “switched plate” outlets. That means that electricity is only going to that outlet when the garbage disposal is “switched on” which means your pump will not work unless the garbage disposal is turned on. In this case, installing a separate outlet that will provide continuous power is necessary. If you don’t feel comfortable working with electricity, call a professional electrician. It’s an easy installation.

Видео Instant Hot Water - Save Water Every Month - Do It Yourself канала Your New House